The fuel pump and the engine cooling fan(s) may run during the following procedure. Note: Do not start a reprogramming session with a low battery in the vehicle and programming tool. Insert VIN number and Tear Tag information Turn off the ignition when run the Ford software.) (* To write the VIN on a used module when original PCM is not present. Purchase Ford day subscription from Ford Service Info website The Autel IM608 does not have the “Programmable Module Installation” feature, use Ford’s OEM software to complete the programming task. Go to Ford Diagnostic Menu->Auto Scan->Programming->Programmable Module Installation With this vehicle 2001 F-250 it does not have this functionality on the IM608 so to do this procedure will be using J2534 with the OEM subscription. Next it will then transfer all the information to the replace module. All you need to do is click programming and look for a programmable module installation (PMI) which is a sequence in that the software will save all the original PCM’s information in IM608, then prompt you when to put the replacement module on it. Normally IM608 alone can do this procedure. Not able to write VIN on the used PCM module after PCM replacement.Īutel MaxiIM IM608 & MaxiFlash J2534 (The module is in default package)
0 Comments
Leave a Reply. |